Cisco 67x DSL Modem Setup

1.) Unpack the DSL modem.

2.) This is the rear of the Cisco 67x. Notice that the Modem's jacks are labeled and color coded.

• The Power cord plugs into the jack labeled PWR.
• The Ethernet (yellow) cable plugs into the jack labeled ENET.
• The Management (Blue) cable plugs into the jack labeled MGMT.
• The Phone Line (pink) plugs into the jack labeled WALL.

3) This is what the modem should look like. When finished.

Q: How Do I Configure the Cisco 675 DSL Modem for PPP Mode?
A: Login with Hyperterminal. (Click Here for Commands)

Q: How Do I Configure the Cisco 675 DSL Modem for Bridging Mode?
A: Login with Hyperterminal. (Click Here for Commands) Note: Bridging is needed for special cases only. Lonetree suggests PPP.

Q: How Do I Configure the Cisco 678 DSL Modem for PPP Mode?
A: Login with Hyperterminal. (Click Here for Commands)

Q: How Do I Configure the Cisco 678 DSL Modem for Bridging Mode?
A: Login with Hyperterminal. (Click Here for Commands) Note: Bridging is needed for special cases only. Lonetree suggests PPP.